logo

Lithiumate™ Manual

index reference description_specs comm_specs config_soc_display_can_specs

Configurable SOC Display CAN specs

Specifications for the CAN Bus messages used by the 6DS0000E SOC display

These are the CAN bus specifications for the configurable Elithion SOC display, 6DS0000E.

back to topReceive

The SOC display listens to the following CAN messages.

Notes:

  • Message rate: 5 s max
  • Length: 3 bytes
  • CAN communication standard, 125, 250, or 1 Mbps, configurable
  • Standard addressing (CAN 2.0 A) (not extended)
Function ID Length Byte 0 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 Byte 7
SOC bar 680h 3 25h FFh SOC (1) -
Status LEDs 1Eh Status (2)
CAN bus speed configuration 7FFh 8 12h 34h 56h 78h 9Ah BCh 04h 0Fh, 00, 01, 03 (3)
 
 
  1. State of charge [%] (0 to 64h)
    • 00h: 0 % - All LEDs off
    • 0Ah: 10 % - Bottom LED on
    • 14h: 20 % - 2 bottom LEDs on
    • 1Eh: 30 % - 3 bottom LEDs on
    • 28h: 40 % - 4 bottom LEDs on
    • 32h: 50 % - 5 bottom LEDs on
    • 3Ch: 60 % - 6 bottom LEDs on
    • 46h: 70 % - 7 bottom LEDs on
    • 50h: 80 % - 8 bottom LEDs on
    • 5Ah: 90 % - 9 bottom LEDs on
    • 64h: 100 % - All LEDs on
  2. Status LEDs, 0 = 0n
    • bit 0: Bottom LED, Blue (powered by the source)
    • bit 1: 2nd LED, Green (Contactors on)
    • bit 3: 3rd LED, Yellow (powered by the load)
    • bit 4: 4th LED, Amber (current limited)
    • bit 5: Top LED, Red (warning or fault)
  3. CAN bus speed configuration.
    The value is validated: there is no risk of bricking the display by programming an invalid value
    • 0Fh for 1 Mbps
    • 00h for 500 kbps
    • 01h for 250 kbps
    • 03h for 125 kbps
back to topTransmit

The display transmits no messages.

e-logo

© 2008~2024 Elithion™, LLC. All rights reserved, except where noted by CC mark. Page published on May 07 2024.
The Elithion brand and the 'ə' (upside down 'e') logo are Trademarks of Elithion LLC. Graphic design by morninglori

 

In this page: