home support product_info components displays 6DS0003K

6DS0003K - SOC display - OBSOLETE

Battery status display module with LED bar graph and CAN Bus interface

This standard Battery Status display module includes:
• A 10-LED bar graph to indicate State Of Charge (SOC)
• Five separate status LEDs
Communication is through the CAN bus (500 kHz only)
The small module is ready to be installed behind a panel.
It requires a nominal 12 Vdc supply to operate.

The SOC display is connected to the CAN bus and a 12 V power source through a 4-pin connector.

SOC displayClick picture to enlarge
SOC display

Specifications

If used with an Elithion BMS controller, the standard behavior of the display is:

  • The LED bar shows the SOC, in 10 % increments:
  • The five LEDs indicate the state of the BMS:
    •     Red= Fault (e.g.: plugged in while trying to drive off) {In Rev 1.05+, it is also lit in case of warning}
    •     Amber = Current limited (reduced charging or discharging limit)
    •     Yellow = Load is on (e.g.: ignition is on)
    •     Green = Enabled (contactors are on, if used)
    •     Blue = Source is on (e.g.: plugged in to charge)

Ordering

OBSOLETE

 

In this page:
Specifications
Ordering
 
© 2008~2024 Elithion™, Inc.. All rights reserved. The Elithion brand and the logo with an 'ə' (upside down 'e') are Trademarks of Elithion Inc.
Policies - Contact us - Mobile site Page published on May 04 2024.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Pop-up enlargement